Silicon Rubber Heater Width X Length 50 X 100 – 300 X 300
Part Number: 0052-17-99-03

[Features]
· Since gentle heat is applied to a wide area, there are no hot spots (local heating) and components of the substance are not changed.
· Since it is soft, it reliably fits to the heating surface.
· Supports complex shapes such as notches and drilled holes.
· The thin and light characteristics enable extremely high precision temperature control.

Specificationtitle

• Product Model

  Heater

• Operational Temperature Range(°C)

  -70～+260

• Length(mm)

  200

• Width(mm)

  50

• Withstand Voltage

  1,500 V/Minute or 1,800 V/Second

• Insulation Resistance

  1000MΩ or greater /DC 500 V

• TGK Code

  0052179903

• Feature 1

  -

• Feature 2

  -

• Feature 3

  -

• Structure

  This surface heater, which is integrated with a low-profile sheet, lays out the resistance element on a preset pattern in between two silicone rubber sheets, pressurizes it after removing the air inside and finally provides a heating cure. Additionally, the silicone rubber sheet is filled and reinforced with glass fiber, so its structure has both excellent mechanical strength and electric properties. The takeout location of the lead wire can be designated freely, but it is always pulled from the tip center portion of the long side of heater using a fluoropolymer covered wire. Unless specified, the length of the lead wire is cut off at 300 mm.

• Note

  Use voltage regulator.

• Sheet Material

  Glass Fiber Reinforced Heat Resistant Silicone Rubber Sheet

• Resistance Element

  Nickel-Chromium Alloy (80/20 NiCr)

• Lead Wire

  fluoropolymer Coated Nickel Electrical Wire

• Capacity Tolerance(W)

  ±10% (however, ±15% for 100 or lower)

• Rated Current(V)

  120

• Dimensions Tolerance (Surface Direction)

  100 mm or less: ±0.75 mm / 300 mm or less: ±1.0 mm